Research on Machining and Positioning of the Space Double Deflector Plane and the Oblique Hole of Deflector Groove

Abstract

In order to solve the problems of clamping and positioning of space double deflector plane and oblique hole of deflector groove during machining. This paper studies the bracket parts when milling, the locating angle and the orientation angle and the key to the angle were calculated by the method of V-spherical figure, H-spherical figure and W-spherical figure respectively. At the same time, the calculation method of spatial angle of sliding core parts in milling is also studied. Using the V-spherical graph method, H-spherical graph method and W-spherical graph method to calculate the locating angle and the orientation angle. The results show that the three methods are accurate and feasible.